Description

Product Parameters
- Brand: ABB
- Model: NDCU-33CX, PN:3AUA0000052751
- Composition: AMC-33CX (150MHz) + NIOC-02C I/O
- Applicable converter: ACS800-67 (air-cooled), ACS800-67LC (liquid-cooled) DFIG converter
- Communication: PPCS fiber bus, encoder interface, digital/analog I/O, fieldbus to WTC turbine controller
- Power supply: 24 VDC
- Operating temperature: 0 ~ 60°C
- Status: Obsolete wind spare, mostly refurbished / surplus stock
Advantages and Features
DTC direct torque control for doubly-fed rotor excitation. Supports low voltage ride-through (LVRT) and grid disturbance requirements. Fiber PPCS link provides strong anti-interference inside high-power cabinet. Integrated I/O for encoder, bearing temperature, safety chain and turbine interlock. Stores fault snapshots and waveform traces for failure analysis. It acts as the main interface between turbine controller WTC and the whole converter system.
Application Cases and Application Fields
Only for DFIG wind turbine ACS800-67/67LC converters. It controls rotor excitation, active/reactive power regulation. If NDCU-33CX fails, the rotor-side converter cannot work, the turbine will trigger trip. Replacement restores rotor control and grid-tie function.
Comparisons with Competing Products
- NDCU-33CX: Rotor side master; RDCU-12C: Grid side master, cannot be swapped
- NDCU-33C vs NDCU-33CX: Different hardware revision and firmware compatibility
- Not compatible with ordinary ACS800 industrial multi-drive, not interchangeable with NAMU-01C measurement unit
Selection Suggestions and Precautions
Confirm full part number 3AUA0000052751 and check firmware version. For refurbished units, test fiber ports, encoder, I/O channels before installation. Perform turbine lockout and cut converter power before replacement. After installation, download matching DFIG application firmware, verify PPCS communication, encoder signal and power regulation, confirm that the ABB NDCU-33CX works reliably.



Reviews
There are no reviews yet.