ABB NDCU-33CX 3AUA0000052751

¥9,999.00

NDCU-33CX is the rotor-side main control unit for ABB ACS800-67 / ACS800-67LC doubly-fed wind turbine converters. It consists of AMC-33CX processor board + NIOC-02C I/O board. It runs DFIG vector control, torque/power regulation, grid code and fault ride-through logic. It communicates with rotor-side INU power modules via PPCS fiber optic bus (through APBU optical splitter), and coordinates with grid-side RDCU-12C. Wind maintenance engineers replace this unit to restore rotor converter control.

Category:

Description

Product Parameters

  • Brand: ABB
  • Model: NDCU-33CX, PN:3AUA0000052751
  • Composition: AMC-33CX (150MHz) + NIOC-02C I/O
  • Applicable converter: ACS800-67 (air-cooled), ACS800-67LC (liquid-cooled) DFIG converter
  • Communication: PPCS fiber bus, encoder interface, digital/analog I/O, fieldbus to WTC turbine controller
  • Power supply: 24 VDC
  • Operating temperature: 0 ~ 60°C
  • Status: Obsolete wind spare, mostly refurbished / surplus stock

Advantages and Features

DTC direct torque control for doubly-fed rotor excitation. Supports low voltage ride-through (LVRT) and grid disturbance requirements. Fiber PPCS link provides strong anti-interference inside high-power cabinet. Integrated I/O for encoder, bearing temperature, safety chain and turbine interlock. Stores fault snapshots and waveform traces for failure analysis. It acts as the main interface between turbine controller WTC and the whole converter system.

Application Cases and Application Fields

Only for DFIG wind turbine ACS800-67/67LC converters. It controls rotor excitation, active/reactive power regulation. If NDCU-33CX fails, the rotor-side converter cannot work, the turbine will trigger trip. Replacement restores rotor control and grid-tie function.

Comparisons with Competing Products

  • NDCU-33CX: Rotor side master; RDCU-12C: Grid side master, cannot be swapped
  • NDCU-33C vs NDCU-33CX: Different hardware revision and firmware compatibility
  • Not compatible with ordinary ACS800 industrial multi-drive, not interchangeable with NAMU-01C measurement unit

Selection Suggestions and Precautions

Confirm full part number 3AUA0000052751 and check firmware version. For refurbished units, test fiber ports, encoder, I/O channels before installation. Perform turbine lockout and cut converter power before replacement. After installation, download matching DFIG application firmware, verify PPCS communication, encoder signal and power regulation, confirm that the ABB NDCU-33CX works reliably.

Reviews

There are no reviews yet.

Be the first to review “ABB NDCU-33CX 3AUA0000052751”

Your email address will not be published. Required fields are marked *

Post comment