YOKOGAWA ALP121

¥9,999.00

The ALP121 is a PROFIBUS‑DP master communication module for Yokogawa CENTUM VP DCS, mounted on AFV30/AFV40 FCS field control station or ANB10/ANB11 ESB node unit. It exchanges cyclic I/O data between the CENTUM VP controller and PROFIBUS‑DP slave devices such as drives, remote I/O, valve positioners and field instruments. Maintenance engineers replace this module to restore PROFIBUS bus communication for the DCS control loop. It supports dual redundant master configuration for high availability.

Category:

Description

Product Parameters

  • Brand: Yokogawa
  • Model: ALP121
  • Protocol: PROFIBUS‑DP (Master)
  • Port: 1 × DB9 female RS485, galvanic isolation between field side and ESB bus
  • Baud rate: 9.6 kbps ~ 12 Mbps
  • Max distance: 1200 m @ 9.6 kbps
  • Data capacity: 1000 words per module; up to 200 communication definitions
  • Power consumption: Max 0.7 A
  • Compatibility: CENTUM VP, AFV30/AFV40 FCS, ANB10/ANB11 ESB node
  • Redundancy: Support dual redundant ALP121 pair (requires redundant PROFIBUS slaves)
  • Software: CS3000 / VP engineering tool
  • Operating temperature: 0 ~ 60°C
  • Status: Mature DCS communication spare, available new or refurbished

Advantages and Features

Isolated PROFIBUS interface protects the DCS ESB backplane from field surge. Redundant master mode can realize seamless bus switchover without process interruption. It supports online device addition and parameter modification. Built-in bus diagnosis, slave status and fault alarm upload to HMI. It uses the ESB bus to exchange data with FCS, with high cyclic refresh stability.

Application Cases and Application Fields

Widely used in chemical, petrochemical, refining, power, water treatment and pulp & paper with CENTUM VP DCS. Typical scenarios: communicate with variable frequency drives, PROFIBUS remote I/O, intelligent valve positioners and package skid control systems. When PROFIBUS communication fails caused by ALP121 fault, replacement recovers the field bus data exchange.

Comparisons with Competing Products

ALP121 = PROFIBUS‑DP master; ALR121 is serial RS422/485 module, not interchangeable. ALP111 is older PROFIBUS module for legacy FCS. It is a dedicated CENTUM VP ESB bus module and cannot be used on other DCS racks. General PROFIBUS gateways have higher latency and do not integrate tightly with VP tag database.

Selection Suggestions and Precautions

Confirm suffix code (ALP121‑S00 standard version, G3 vibration option available). For refurbished units, test bus port, slave scanning and ESB communication before installation. Hot-swap is supported, but monitor the process carefully during replacement. After installation, download the engineering configuration, scan PROFIBUS slaves, verify I/O data and fault alarm, confirm that the YOKOGAWA ALP121 works reliably.

Reviews

There are no reviews yet.

Be the first to review “YOKOGAWA ALP121”

Your email address will not be published. Required fields are marked *

Post comment