Description

Specifications
- Part Number: 3500/64M, 140734-05
- Series: Bently Nevada 3500 Machinery Protection System
- Channels: 4 isolated dynamic pressure input channels
- Transducer support: 2-wire constant current or 3-wire 10kΩ pressure sensors
- Keyphase input: Supported for synchronous frequency and spectrum analysis
- Filter: Configurable bandpass filter and notch filter
- Output: Isolated 4–20mA recorder output for DCS
- Power supply: Powered by rack backplane, typical power consumption 3.5~4W
- Indicators: OK, communication and channel alarm LEDs
- Operating temperature: -30°C ~ +65°C
- Storage temperature: -40°C ~ +85°C
- Humidity: 0–95%, non-condensing
- Mounting: Single full-height slot in the 3500 rack
Advantages and Features
BENTLY 3500/64M 140734-05 is the dedicated card for gas turbine combustion oscillation protection. Each channel can set independent Alert and Danger thresholds. It supports waveform and spectrum capture for combustion fault analysis. Built-in transducer fault diagnosis detects broken cables and sensor failures. It has conformal coating and good EMC performance, suitable for gas turbine cabinet environments with high temperature and strong electromagnetic interference. It supports hot-swap replacement without interrupting other monitoring channels of the rack.
Application & Case
It is mainly used in combined-cycle gas turbine units. In a gas turbine TSI maintenance project, 3500/64M 140734-05 replaced the faulty dynamic pressure module. After configuration download, combustion pulsation monitoring, alarm and protection interlock functions returned normal.
Comparison
It is a special dynamic pressure acquisition card, different from vibration/displacement monitor cards such as 3500/40M and 3500/42M. Different suffix codes of 3500/64M correspond to different rear terminal hardware and cannot be interchanged directly. It cannot work outside the 3500 rack and is incompatible with the 1900 series monitors.
Selection Notes
Confirm the full part number 140734-05. It is used for gas turbine combustion pressure pulsation monitoring, not for conventional shaft vibration and displacement measurement. Verify the matching rear terminal board.
Precautions
Power off the rack and take ESD protection before replacement. Check transducer wiring and polarity strictly. After installation, download rack configuration, calibrate each channel, test 4-20mA output, alarm relay action and waveform upload to System1 before putting into service.



Reviews
There are no reviews yet.