BENTLY 146031-01

¥9,999.00

BENTLY 146031-01 refers to the 3500/22M TDI (Transient Data Interface) module. It belongs to the Bently Nevada (GE Vernova) 3500 machinery protection and monitoring system. Acting as the core Ethernet gateway between the rack and the System 1 condition monitoring software, it uploads static data such as vibration, shaft displacement and rotational speed. With proper licensing, it can capture transient waveform data for fault diagnosis, spectrum analysis and event playback of steam turbines, compressors, fans and other large rotating machinery. It is installed in Slot 1 of the 3500 rack next to the power supply.

Category:

Description

Specifications

  • Part Number: 146031-01, Model: 3500/22M
  • Series: Bently Nevada 3500 Machinery Protection System
  • Communication: 10/100 Mbps Ethernet RJ45, proprietary Bently TDI protocol
  • Power Consumption: 10.5 W
  • Operating Temperature: -30°C ~ +65°C
  • Storage Temperature: -40°C ~ +85°C
  • Humidity: 0–95%, non-condensing
  • Dimensions: 241.3 × 24.4 × 241.8 mm, Weight: 0.91 kg
  • Indicators: LEDs for power, network, data and rack trip status
  • Mounting: Full-height slot in the 3500 rack

Features

BENTLY 146031-01 aggregates data from all monitoring modules in the rack, and transmits real-time readings, alarms and event logs to the System 1 host. With enabled licensing, it captures transient waveforms for analysis of rotor rub, unbalance, instability and other faults. It supports link diagnostics. Importantly, local protection logic of the 3500 system remains functional even if this communication module or Ethernet link fails. It is compatible with all 3500 series monitoring cards such as 3500/40M and 3500/42M, and is a common spare for vibration monitoring cabinets in power plants.

Application & Case

It is widely used for online monitoring of steam turbines, gas turbines, blowers, air compressors and turbo compressors. In a turbine monitoring retrofit project at a power plant, the faulty TDI module was replaced with BENTLY 146031-01. Communication between the 3500 rack and System 1 was restored, including vibration, displacement, speed values, alarm transfer and transient waveform acquisition.

Comparison

It is only a communication gateway and does not acquire sensor signals. Its function differs completely from signal acquisition modules such as 3500/40M and 3500/42M. The legacy 3500/22 and updated 3500/22M have different hardware and firmware and are not directly interchangeable. Generic Ethernet modules cannot replace it because they do not support the proprietary Bently TDI protocol.

Selection Notes

Confirm the system is a Bently 3500 rack, and verify slot requirements and firmware version. This module handles data upload only and does not participate in trip protection logic. It is not compatible with the older 3300 monitoring series.

Precautions

Power off the rack before removal and installation, and take ESD precautions. After installation, check cables and IP settings. Refresh the rack in System 1, verify channel readings, alarm transmission and transient waveform capture. Confirm stable communication before putting it into service.

Reviews

There are no reviews yet.

Be the first to review “BENTLY 146031-01”

Your email address will not be published. Required fields are marked *

Post comment