ABB 3BDH000741R1 CTI 21-P Ex

¥9,999.00

CTI 21-P Ex is an intrinsically safe temperature / analog input module for ABB AC870P / Advant OCS / 800xA DCS local I/O system. It is used for temperature and low-level analog signal acquisition in hazardous areas, with built-in intrinsic safety limiting circuit, no separate safety barrier required. Maintenance engineers replace this module to restore temperature measurement loops of thermocouple, RTD and mV signals in explosive zones.

Category:

Description

Product Parameters

  • Brand: ABB
  • Model: 3BDH000741R1 (CTI 21-P Ex)
  • Type: Intrinsically safe temperature / analog input module
  • System: AC870P local I/O, Fnet bus
  • Input channels: 16 or 32 channels, channel-isolated
  • Supported signals: Pt100/Ni100 RTD, thermocouple, mV, resistance signals
  • Explosion protection: [EEx ib] IIC, ATEX / IECEx, suitable for Zone 1 hazardous gas area
  • A/D resolution: 16 bit
  • Features: Cold junction compensation, wire resistance compensation, linearization, sensor break detection
  • Communication: Fnet redundant field bus to AC870P controller
  • Operating temperature: 0 ~ 60°C
  • Status: Legacy Advant series spare, discontinued, mainly refurbished / surplus stock

Advantages and Features

Channel-by-channel galvanic isolation, each input channel independent. Integrated intrinsic safety design, can directly connect intrinsically safe field sensors in hazardous area. Automatic linearization for thermocouple and RTD, cable resistance compensation improves measurement accuracy. Sensor open-circuit diagnostic, fault alarm upload to operator station. Supports redundant configuration, hot-swap in compatible rack. High anti-interference for heavy process industry.

Application Cases and Application Fields

Widely used in petrochemical, refinery, gas plant, chemical process with ABB Advant OCS / 800xA. Typical: furnace temperature, reactor temperature, pipeline temperature, low-level process signal collection. When the temperature measuring point fails due to module damage, replacement restores temperature monitoring and interlock.

Comparisons with Competing Products

CTI 21-P Ex is the intrinsically safe version; CTI 21-P is the non-Ex ordinary temperature module, cannot be mixed. CBI 21-P Ex is intrinsic safety digital input module, different function. It belongs to AC870P local I/O via Fnet bus, not S800 I/O. It cannot be replaced with general AI modules of other DCS brands.

Selection Suggestions and Precautions

Confirm the full part number 3BDH000741R1, distinguish Ex version and non-Ex version. For refurbished units, test each channel RTD/TC sampling, sensor break detection and Fnet communication before installation. For hazardous area related loops, apply bypass before replacement. After installation, download configuration, check measurement value and fault alarm, remove bypass after confirmation, confirm that the ABB 3BDH000741R1 CTI 21-P Ex works reliably.

Reviews

There are no reviews yet.

Be the first to review “ABB 3BDH000741R1 CTI 21-P Ex”

Your email address will not be published. Required fields are marked *

Post comment