EPRO MMS3120 022-000 9100-03047-01

¥9,999.00

EPRO MMS3120/022-000, part number 9100-03047-01, belongs to the EPRO MMS3000 machinery monitoring series (now Emerson). It is a dual-channel casing / bearing absolute vibration monitor, designed for seismic velocity sensors such as PR9268. It measures bearing housing vibration velocity, acceleration and displacement, provides Alert / Danger alarm relay outputs and isolated 4–20mA analog signals to DCS. It complies with API 670 and VDI 2056 for turbine, compressor and fan protection. It can be rack-mounted in MMS3000 racks or installed locally near the machine.

Category:

Description

Specifications

  • Part Number: MMS3120/022-000, 9100-03047-01
  • Series: EPRO MMS3000
  • Channels: 2 independent seismic vibration input channels
  • Supported sensors: PR9266 / PR9268 electrodynamic velocity transducers
  • Measurement: Vibration velocity (mm/s RMS), acceleration, displacement
  • Analog outputs: 2 × isolated 4–20 mA (per channel)
  • Relay outputs: Configurable Alert, Danger and OK status relay
  • Power supply: Redundant 24 VDC (18–36 VDC), power consumption approx. 2.5 W
  • Configuration: MMS3910W configuration software / DIP switch
  • Indicators: OK, channel alarm LEDs
  • Operating temperature: -20°C ~ +65°C
  • Storage temperature: -30°C ~ +90°C
  • Humidity: 0–95%, non-condensing
  • Enclosure: Aluminium housing, IP65

Advantages and Features

EPRO MMS3120 022-000 9100-03047-01 has built-in sensor cable break and signal out-of-range diagnosis. Two independent channels can monitor two bearing points at the same time. Buffered raw signal output is available for spectrum analysis. It supports redundant DC power supply to improve reliability. The alarm threshold and measurement mode can be set by software. It has good EMC performance for power plant and petrochemical high EMI cabinet environments.

Application & Case

It is widely used for steam turbine, gas turbine, blower, pump and compressor bearing housing vibration monitoring. In a thermal power TSI overhaul project, MMS3120 022-000 9100-03047-01 replaced the faulty vibration transmitter. After configuration, casing vibration measurement, 4–20mA transmission and alarm relay action worked normally.

Comparison

Compared with MMS3210 (for eddy current shaft relative vibration probes), MMS3120 is dedicated to seismic absolute vibration. Different suffix codes of MMS3120 correspond to different sensor types and output options and are not interchangeable. It is part of the old MMS3000 platform and cannot be used in AMS6500 rack or Bently 3500 rack.

Selection Notes

Confirm the full part number 9100-03047-01. Confirm it matches seismic velocity sensors (not eddy current probes). This is an obsolete legacy EPRO spare.

Precautions

Cut off 24VDC power before replacement and take ESD protection. Check sensor shield grounding strictly. After installation, configure parameters via MMS3910W, calibrate each channel, test 4–20mA output and alarm relay logic before putting into service.

Reviews

There are no reviews yet.

Be the first to review “EPRO MMS3120 022-000 9100-03047-01”

Your email address will not be published. Required fields are marked *

Post comment