EMERSON 9199-00002 A6120

¥9,999.00

EMERSON 9199-00002 A6120 is a dual-channel absolute casing vibration monitor module for Emerson AMS 6500 / CSI 6500 machinery health monitoring system (original EPRO). It is designed for casing seismic vibration measurement, compatible with velocity sensors or piezoelectric accelerometers (with internal integration to velocity). It supports PeakVue bearing fault diagnosis, provides alarm and trip protection for rotating equipment, and transmits vibration data to AMS monitoring software and DCS system. It is a hot-swappable plug-in card for the IMR6500 rack and conforms to API 670 standard.

Category:

Description

Specifications

  • Part Number: A6120, 9199-00002
  • Series: Emerson AMS6500 / CSI6500 Machinery Health Monitor
  • Channels: 2 independent isolated differential input channels
  • Supported sensors: Velocity transducer PR9266/9267/9268, piezoelectric accelerometer
  • Frequency range: 10 Hz ~ 1000 Hz (adjustable filter)
  • Measurement: Vibration velocity (mm/s RMS), peak-peak displacement
  • Isolation: 1500V RMS channel to backplane isolation
  • Power supply: 24 VDC, max 6W
  • Output: Buffered raw signal, 4–20 mA analog output
  • Communication: Backplane bus, Modbus TCP
  • Indicators: OK, fault, channel alarm LEDs
  • Operating temperature: -40°C ~ +70°C
  • Humidity: 0–95%, non-condensing
  • Mounting: IMR6500 rack plug-in module, hot swap

Advantages and Features

EMERSON 9199-00002 A6120 integrates PeakVue algorithm to capture impact signals for early bearing damage detection. Each channel can set independent Alert and Danger thresholds. It supports waveform capture and spectrum analysis for fault tracing. It has built-in sensor cable break diagnosis. Hot-swap design allows replacement without shutting down the whole rack, which improves availability for turbine, fan and compressor monitoring cabinets. It adopts anti-interference design, suitable for high EMI industrial site.

Application & Case

It is widely used for steam turbine, gas turbine, blower, pump and compressor casing vibration monitoring in power plants and petrochemical plants. In a thermal power TSI overhaul project, 9199-00002 A6120 replaced the faulty casing vibration module. After configuration download, casing vibration measurement, alarm relay and PeakVue bearing monitoring function returned normal.

Comparison

Compared with A6110 (shaft relative vibration monitor with eddy current probe), A6120 is dedicated to casing absolute vibration. A6125 is another casing vibration variant with different firmware and channel definition, not interchangeable. It only works inside AMS6500/CSI6500 rack; it cannot be used with Bently 3500 rack.

Selection Notes

Confirm full part number 9199-00002 A6120, confirm it is for casing seismic vibration instead of shaft relative vibration. Verify matching IMR6500 rack and rear terminal unit. It follows API 670 machinery protection specification.

Precautions

Power off the module slot or use hot-swap operation strictly according to Emerson procedure, take ESD protection. Check sensor shield wiring and grounding. After installation, download rack configuration, calibrate channels, test 4-20mA output, alarm/trip logic and PeakVue waveform upload before putting into service.

Reviews

There are no reviews yet.

Be the first to review “EMERSON 9199-00002 A6120”

Your email address will not be published. Required fields are marked *

Post comment