BENTLY 350022M 138607-02

¥9,999.00

BENTLY 3500/22M 138607-02 is the TDI (Transient Data Interface) gateway module of the Bently Nevada 3500 machinery protection system. It is installed in Slot 1 (RIM slot) adjacent to the rack power supply. It acts as the communication bridge between the whole 3500 rack and System 1 condition monitoring software. It collects steady-state values, alarm events and, with valid licensing, transient waveform data from all M-series monitor cards such as 3500/40M and 3500/42M, and transmits data to the host via Ethernet. It also supports rack configuration and parameter download. Importantly, the protection trip function of all monitor cards works independently and is not affected if this TDI communication module fails.

Category:

Description

Specifications

  • Part Number: 3500/22M, Order code: 138607-02
  • Series: Bently Nevada 3500 TSI system
  • Power consumption: 10.5 W
  • Communication: 10/100 Mbps Ethernet RJ45, USB port for local configuration
  • Indicators: LEDs for OK, TX/RX, TMR status and rack trip
  • Operating temperature: -30°C ~ +65°C
  • Storage temperature: -40°C ~ +85°C
  • Humidity: 0–95%, non-condensing
  • Installation: Full-height slot inside the 3500 rack
  • TMR option: This part number supports TMR triple redundant rack configuration

Advantages and Features

BENTLY 3500/22M 138607-02 integrates the old rack interface function and high-speed transient data acquisition function. It supports fault waveform capture for post-event analysis of turbine, compressor and fan faults such as rotor rub and unbalance. It has built-in rack diagnostic function. The front reset button can be used for alarm reset, and a lock function prevents unauthorized modification of configuration. It is widely used for steam turbine and gas turbine supervisory instrumentation cabinets in power plants.

Application & Case

It is used in large rotating equipment monitoring cabinets of thermal power plants, combined-cycle power stations and petrochemical plants. In a turbine TSI maintenance project, 3500/22M 138607-02 replaced the faulty TDI module. After commissioning, vibration, shaft displacement and speed data, alarm messages and transient waveform uploading to System 1 returned normal.

Comparison

Compared with 146031-01 (another 3500/22M ordering variant), 138607-02 is a different revision. They are hardware version variants of the same 3500/22M TDI series and cannot be replaced directly without firmware verification. It is only a communication gateway and does not process probe signals. It is not interchangeable with monitor cards like 3500/40M. Generic Ethernet modules cannot recognize the proprietary Bently TDI protocol.

Selection Notes

Confirm the full part number 138607-02 and confirm whether the rack is TMR configuration. It must be placed in Slot 1 of the 3500 rack. It is not compatible with the old 3300 series monitoring racks.

Precautions

Power off the rack and take ESD protection before replacement. Check Ethernet cable and IP address after installation. Refresh rack information in System 1, verify channel readings, alarm upload and transient waveform capture. Confirm stable communication before putting into service.

BERGHOF CDIO 16/16-0,5
BERGHOF CDIO 16/16-0,5-1131
ABB CDP312R
CUTLER-HAMMER CE15KN3

Reviews

There are no reviews yet.

Be the first to review “BENTLY 350022M 138607-02”

Your email address will not be published. Required fields are marked *

Post comment