GE 531X301DCCBAG1

Technical Parameters

• Product Type: DC link capacitor / filter board assembly

• Capacitance: 1200 – 2200 µF (standard – BAG1 specific)

• Voltage rating: 900 VDC

• Current rating: 250 – 450 A continuous

• Bleeder resistors: Two 15 kΩ / 75 W

• Thermal protection: 130°C normally-closed thermal switch

• Diagnostic monitoring: Basic – voltage/current monitoring (BAG1 specific)

• Terminal type: Heavy-duty bus-bar terminals (DC+ / DC-) + spring-clamp terminals (auxiliary, 24–16 AWG)

• Conformal coating: Marine-grade (moisture and corrosion resistant) – BAG1 specific

• Mounting: 4× M6 holes (standard GE rack footprint)

• Operating temperature: -20°C to 70°C (extended)

• LED indicators: Power, Fault

Advantages & Features

• Standard capacitance – 2200 µF on GE 531X301DCCBAG1 provides adequate filtering for most applications

• Spring-clamp terminals – Faster auxiliary wiring on GE 531X301DCCBAG1 reduces installation time

• Basic diagnostic monitoring – Voltage/current monitoring on GE 531X301DCCBAG1 enables basic fault detection

• Superior ripple attenuation – High-capacitance design extends IGBT life

• Improved thermal management – Enhanced heat dissipation for reliable operation at high loads

• Marine-grade conformal coating – Protects GE 531X301DCCBAG1 from humidity, salt spray, and corrosive gases

• Extended temperature range – -20°C to 70°C for harsh environments

• Drop-in replacement – Direct replacement for earlier DCC revisions

Application Cases

• Large-scale retrofit – System integrator used spring-clamp terminals on GE 531X301DCCBAG1 for 15 drive installations, reducing auxiliary wiring time by 30%

• General industrial drive – Manufacturing plant used GE 531X301DCCBAG1 for standard pump control; reliable filtering and thermal management ensured long-term operation

• Offshore platform – Corrosive environment used GE 531X301DCCBAG1; conformal coating prevented salt spray damage

Competitive Comparison

Selection Suggestions

• Choose GE 531X301DCCBAG1 for standard applications (non-regenerative, moderate braking) requiring fast auxiliary wiring, harsh environment protection, and basic diagnostics

• For applications requiring higher capacitance (heavy regenerative braking) or advanced diagnostics (capacitance/health monitoring), consider enhanced revisions (APM1, AWM1, etc.) instead

• Verify drive frame size (Frame 6, 7, or 8) before ordering GE 531X301DCCBAG1

• Verify auxiliary wiring is within 24–16 AWG range for spring-clamp terminals

• Confirm regulator board compatibility – works with 531X111, 531X139, and 531X305 series

• Prefer remanufactured units with new capacitors, terminals tested, and coating intact

Precautions

• Always discharge the DC bus (wait 5+ minutes) before handling GE 531X301DCCBAG1 – capacitors store lethal energy

• Do not operate without proper cooling – thermal damage will occur

• Torque bus-bar bolts to 8–10 N·m – over-tightening cracks the PCB

• For stranded wires on spring-clamp terminals, use ferrules to prevent strand fraying

• Insert auxiliary wires fully until the wire stop is reached – partially inserted wires cause intermittent connections

• Check IGBT modules for shorts before installing a replacement GE 531X301DCCBAG1

• Inspect conformal coating for scratches or cracks before installation – damaged coating exposes the PCB to corrosion

• Replace all capacitors if the board has been in storage > 5 years

• Store spare boards in ESD-safe packaging